Tämä sivu on konekäännetty ja odottaa tarkistusta. Englannin- ja hollanninkieliset versiot ovat määrääviä.
Asennus- ja kytkentäohje

Use packaging plastic when fitting clamp brackets to avoid damaging or scratching the bar's surface finish.
Valmistajan ilmoittama tieto
In accordance with VVFS 2003:27 (Swedish regulation), the product's position lighting must not be used while the vehicle is travelling in traffic on public roads. If the product is fitted to a class 1 motorised implement, it must be installed with a switch for the position lights.
Maintenance & cleaning — Never spray concentrated jets directly at, or use high pressure (pressure washer) on, lamps and other electronic equipment. All our lamps are IP-rated to withstand water and moisture, but for a longer service life, care is recommended when cleaning. On products with a natural anodised surface, do not use alkaline or acidic cleaning agents; these damage the anodised surface. Only use cleaning agents with a pH between 6 and 8. Paint cleaner may be used on heavily soiled surfaces.
a. Change the flash pattern by holding the button pressed for about 1 second. b. To reset the flashlights, hold the button pressed for about 5 seconds. The flashlights return to factory mode #0 (Random). NOTE: R65 is the EU-approved pattern and its use is recommended.
9 - Single (all) (R65 - EU Certified)
Lähde: tehtaan tuoteseloste PD00094 (rev. B), käännetty ruotsista. Alkuperäinen on arkistoitu. Käännetty toimittajan ruotsinkielisestä dokumentaatiosta.