Counterweight bar package 2

Machine brand: Komatsu
Article number: 109070-23
Document: PD00110
Revision: B

Back to product

Mounting, wiring & use

Mounting

Use packaging plastic when fitting clamp brackets to avoid damaging or scratching the bar's surface finish.

Wiring

Wiring 1: Connector DT06-08SA 1. Flashlight (+) 2. Flashlight (-) 3. Flashlight night dimming(+) 4. Position light(+) 5. Position light(-) 6. Work light (+) 7. Work light (-) 8. Not connected
Wiring 2: Connect to switch

Safety & use restrictions

The factory products are intended solely as fixtures for lighting and warning systems.
Under no circumstances may the product be used for towing or as a lifting device.
The product is also not intended for use as a guard rail, handle or step.

Manufacturer specification

In accordance with VVFS 2003:27 (Swedish regulation), the product's position lighting must not be used while the vehicle is travelling in traffic on public roads. If the product is fitted to a class 1 motorised implement, it must be installed with a switch for the position lights.

Flash patterns

a. Change the flash pattern by holding the button pressed for about 1 second. b. To reset the flashlights, hold the button pressed for about 5 seconds. The flashlights return to factory mode #0 (Random). NOTE: R65 is the EU-approved pattern and its use is recommended.

9 - Single (all) (R65 - EU Certified)

Show all programmable flash patterns

0 - Random (default)
1 - Single (split)
2 - Double (split)
3 - Quad (split)
4 - Quint (split)
5 - Mega (split)
6 - Ultra (split)
7 - Single-Quad (split)
8 - Single H/L (split)
9 - Single (all) (R65 - EU Certified)
10 - Single (all) (SAE)
11 - Double (all)
12 - Quad (all)
13 - Quint (all)
14 - Mega (all)
15 - Ultra (all)
16 - Single-Quad (all)
17 - Single H/L (all)
18 - Steady 2 (California)
19 - Steady 4 (all)

Source: factory product sheet PD00110 (rev. B), translated from Swedish. The original is archived. Translated from the supplier's Swedish documentation.