Counterweight bar package 2

Maskinmerke: Komatsu
Artikkelnummer: 109070-23
Dokument: PD00110
Revisjon: B

Tilbake til produktet

Montering, tilkobling & bruk

Montering

Use packaging plastic when fitting clamp brackets to avoid damaging or scratching the bar's surface finish.

Ledningsføring

Ledningsføring 1: Connector DT06-08SA 1. Flashlight (+) 2. Flashlight (-) 3. Flashlight night dimming(+) 4. Position light(+) 5. Position light(-) 6. Work light (+) 7. Work light (-) 8. Not connected
Ledningsføring 2: Connect to switch

Sikkerhet og bruksbegrensninger

The factory products are intended solely as fixtures for lighting and warning systems.
Under no circumstances may the product be used for towing or as a lifting device.
The product is also not intended for use as a guard rail, handle or step.

Produsentspesifikasjon

In accordance with VVFS 2003:27 (Swedish regulation), the product's position lighting must not be used while the vehicle is travelling in traffic on public roads. If the product is fitted to a class 1 motorised implement, it must be installed with a switch for the position lights.

Blinkmønstre

a. Change the flash pattern by holding the button pressed for about 1 second. b. To reset the flashlights, hold the button pressed for about 5 seconds. The flashlights return to factory mode #0 (Random). NOTE: R65 is the EU-approved pattern and its use is recommended.

9 - Single (all) (R65 - EU Certified)

Vis alle programmerbare blinkmønstre

0 - Random (default)
1 - Single (split)
2 - Double (split)
3 - Quad (split)
4 - Quint (split)
5 - Mega (split)
6 - Ultra (split)
7 - Single-Quad (split)
8 - Single H/L (split)
9 - Single (all) (R65 - EU Certified)
10 - Single (all) (SAE)
11 - Double (all)
12 - Quad (all)
13 - Quint (all)
14 - Mega (all)
15 - Ultra (all)
16 - Single-Quad (all)
17 - Single H/L (all)
18 - Steady 2 (California)
19 - Steady 4 (all)

Kilde: fabrikkens produktblad PD00110 (rev. B), oversatt fra svensk. Originalen er arkivert. Oversatt fra leverandørens svenske dokumentasjon.